Windows 2008 ipv6 dhcp configuration

View this "Best Answer" in the replies below ». Popular Topics in General Networking. Spiceworks Help Desk. The help desk software for IT. Track users' IT needs, easily, and with only the features you need. Learn More ». What part is failing? Subnet mask The subnet mask for the IPv4 network to which the computer is attached. Subnet prefix length The subnet prefix length for the IPv6 network to which the computer is attached. If you are unsure of any of this information, you should ask the IT staff.

In many cases, even if you are an administrator, there is a specific person you must ask for the IP address setup that should be used. If no one in your organization has this role yet, this role should be assigned to someone or jointly managed to ensure that IP addresses are assigned following a specific plan.

The plan should detail the following information:. The address ranges that are reserved for network equipment and hardware and which individual IP addresses in this range are currently in use.

Recommended Posts. Report post. Posted May 5, Step 1. When the wizard appears click next. Click on the blue text to continue. Some operations on clients running versions of Windows earlier than Vista with Service Pack 1 are also impacted, including domain join operations performed by the Active Directory Migration Tool or Windows Deployment Services. Share this post Link to post Share on other sites More sharing options Posted May 6, Step 2.

Review the information about DHCP server You will also need to add at least one boot image and one install image in the image store. Step 5. Adding boot. Posted January 27, Posted July 21, Posted July 22, Posted September 17, RGB09 Posted November 14, Posted November 14, Malik4u Posted November 27, Posted November 27, Hi I am following this guide by you This next step will enumerate the network interfaces installed on this client.

We need to get the index number of the interface card we are going to configure to obtain IPv6 addresses automatically. Type netsh int ipv6 show int and press Enter. From the results, we can see that we are using the interface on Idx For these next several steps, when you are instructed to type a command with [index] as an instruction, type the Idx number.

In this case, We now need to disable to default mode for IPv6, which is router discovery. Next we need to tell the interface that we are going to manage the IPv6 address. We can confirm our settings by typing netsh int ipv6 show int [index] and press Enter.

In the above image, we can see that Router Discovery is disabled and Managed Address Configuration is enabled. Martijn said…. Thank you, finally got this ipv6 bussiness working. Currently working towards , but the book didn't comment on how to actually get the dhcpv6 lease. November 23, at AM. Jason Yoder, MCT said…. November 23, at PM. June 16, at AM.